How to terminate an SPLA license


In this article, we will discuss how to kill a Service Provider Licensing Agreement (SPLA) enabled LoadMaster.
SPLA provides for a pool of ready-to-go KEMP LoadMaster licenses which can be licensed and unlicensed on demand. The proper termination of an SPLA enabled LoadMaster will free up that license back to the license pool so that it can be reused.

To terminate an SPLA licence, perform the following steps

1. In the LoadMaster Web User Interface (WUI), go to System Configuration > System Administration > Update License as shown in Figure 1 below.
SPLA-1.png

Figure 1: Update License Page

2. Enter the SPLA KEMP ID credentials that were used to license this SPLA enabled LoadMaster into the KEMP Identifier and Password fields as shown in Figure 2 below.
SPLA-2.png

Figure 2: Enter your SPLA KEMP ID Credentials

3. Click the Kill License button and click OK. as shown in Figure 3 below.

SPLA-3.pngFigure 3: Accept the license termination

The SPLA enabled LoadMaster reboots and returns to the licensing page when the reboot is completed. The associated license is returned to the license pool for future use.
This unit can also be reused
 

Was this article helpful?

0 out of 0 found this helpful

Comments